Shovelhead Shotgun Exhaust Systems For 1966 - 1969 Swingarm Frames

1-3/4" Shotgun Exhaust Systems For 1966 - 1969 Swingarm Shovelheads
These complete exhaust systems and headpipes are intended for use on 1966–1969 Shovelhead engines in swingarm frames ONLY. Heat shields for the rear pipes are recommended.

EXHAUST SYSTEMS WITH SHOTGUN REAR PIPES
These sets fit kick and electric start models with a swingout kicker, but will not work with the large FLH battery. Use a Paughco #718J bracket to mount the rear pipe.

724D1-40 40"-long Slash Cut drag pipes
724D1GM 38"-long Goose Cut muffler set
724D1M 38"-long Slash Cut muffler set_
724D1TM 38"-long Tapered muffler set
724D1MEG 38"-long Megaphone muffler set (shown below on bike)
718J Rear Shotgun pipe hanger bracket for all early and late model swingarm frames (bolts to the upper shock stud and the rear strut) shown below on bike
412D1R Rear heat shield for Paughco #724D1 series pipe sets (shown below on bike)

‘CLOSE FIT’ SHOTGUN HEADPIPES
For swingarm frames ONLY, but will not work with a large FLH battery. The front pipe tucks up tight under the floorboards for improved cornering clearance.

724D1 24"-long headpipes for tail pipe extensions or universal mufflers
412D1R Rear heat shield for Paughco #724D1 series pipe sets (shown below on bike)

 

Special Notes:
1) Drag pipes are not recommended for use on the street.
2) These pipes have less ground clearance than original equipment and may scrape on hard right hand turns. Do not use these pipes unless the front end is extended at least 4" longer than stock or serious injury may result.